|
|
|
 We're not all autonomous robots who are preprogrammed to always follow rules blindly regardless of what they are. - Ryan Dognaux [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| We're not all autonomous robots who are preprogrammed to always follow rules blindly regardless of what they are. - Ryan Dognaux [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
White Paper Discuss: Tetra Connector In MasterCAM
Thread created automatically to discuss a document in the White Papers.
Tetra Connector In MasterCAM by Jon K. If anyone needs this file, it is for the Tetra Connectors in MasterCAM version 9.1 My team was planning on using it, then we were able to get them done by an engineer with laser cutting capabilities, but here is the file. Last edited by Jon K. : 09-01-2005 at 20:20. 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| White Paper Discuss: Users Guide to Autodesk Inventor | CD47-Bot | Extra Discussion | 2 | 18-12-2006 17:45 |
| White Paper Discuss: Continuous Improvement Process for FIRST Teams | Chris Fultz | Team Organization | 2 | 05-01-2005 20:52 |
| White Paper Discuss: Comparison Paper for Teacher Involvement | CD47-Bot | Extra Discussion | 1 | 13-11-2004 00:09 |
| White Paper Discuss: Karthik's Championship Event Data | CD47-Bot | Extra Discussion | 20 | 13-04-2004 08:17 |
Linear Mode
