|
|
|
 Use these tools as a starting point, not as an end product. - Tom Bottiglieri [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Use these tools as a starting point, not as an end product. - Tom Bottiglieri [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
10-01-2005, 22:23
|
|||||
|
|||||
|
Re: Pneumatic pressure switch
The pressure switch has two settings.
At the high point (115 - 120 usually), the sensor will send a signal to the control. At this point, the compressor should be shut off. As you use pneumatics, the pressure will drop. When you reach the low set point (100 - 105 usually), the compressor will come back on. Unless something malfunctions, you should never trip the relief valve. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| connecting pressure switch | kingpin3787 | Pneumatics | 2 | 19-02-2004 21:01 |
| spike for pressure switch? | Rob Colatutto | Rules/Strategy | 4 | 23-02-2003 15:42 |
| lost pressure switch | Josh Hambright | Pneumatics | 0 | 29-01-2003 08:30 |
| Error found in programming for the pump and pressure switch | sjharobotics | Programming | 4 | 06-02-2002 17:46 |
| Pneumatic pressure sensor | Curtis Williams | Pneumatics | 3 | 04-02-2002 20:09 |
Threaded Mode