|
|
|
 The reason I care about it is that I don't want minorities (whether that's females or other racial minorities) to see the STEM world as only inclusive of majorities or men. - Monochron [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Tetra Loading Station
The drawing for the Tetra Loading Station appears to show the side supports at 30 inches apart - if this were so, wouldn't the tetras fall through ...
The pretty pictures in the Comp Manual show a tube structure instead, which is definitely narrower than the tetra sitting on it ! |
|
#2
11-01-2005, 13:26
|
|||||
|
|||||
|
Re: Tetra Loading Station
It's better to consider this file:
http://www2.usfirst.org/2005comp/Dra...TRA_LOADER.pdf |
|
#3
11-01-2005, 14:15
|
|||
|
|||
|
Re: Tetra Loading Station
Quote:
|
|
#4
11-01-2005, 15:49
|
||||||
|
||||||
|
Re: Tetra Loading Station
Remember that the PVC pipes are 30" long. When you add the clovers, each tetra will be a few inches longer then 30" and so should be able to be supported by a structure 30" wide.
It should also be noted that the pretty pictures in the manual are just that, pretty pictures. The figure on page 8 of the Game section has already been shown to be wrong. |
|
#5
11-01-2005, 16:29
|
|||||
|
|||||
|
Re: Tetra Loading Station
At Manchester the supports for the tetra were ~13" apart (inside to inside) and 1.5" wide. I posted a photo in the gallery.
Last edited by Mark McLeod : 11-01-2005 at 16:38. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Q/A questions so far.. | AmyPrib | Rules/Strategy | 49 | 28-01-2005 08:39 |
| Pushing robots out of loading zone | jgannon | Rules/Strategy | 24 | 09-01-2005 18:01 |
| Basic Game Breakdown | Levin571 | General Forum | 34 | 08-01-2005 23:35 |
| Automated Loader without being in loading zone | geeknerd99 | Rules/Strategy | 3 | 08-01-2005 21:57 |
Linear Mode
