|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Help - new interface, old servos
hey guys and gals. my partner and i have been trying to use the nw interface for the 2005 frc with the old servos from the robovation kit. the servos have a 4 pin connector with black, red, yellow and orange wires. however the new interface had a 3-pin connector with labels for a black, red and yellow/white pins at the relay outputs. the 4th-pin from the servo is the orange wire, which isnt labeled on the interface, and it makes the 4-pin connector from the servo too wide to connect onto the new interface. is there any suggestions? any help is appreciated.
your friend Holy One |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Serial/Parallel Interface | mchan1111 | Programming | 2 | 22-10-2004 23:36 |
| 2003 robot controller & interface | LGuY | Control System | 3 | 04-04-2004 16:01 |
| how to create custom interface | _GP_ | Technical Discussion | 1 | 18-01-2004 21:24 |
| Looking for operator interface... Where is it? | mike325 | General Forum | 2 | 07-01-2003 15:28 |
| Need help in creating program to use servo's to shift drive | archiver | 2001 | 19 | 24-06-2002 00:35 |