|
|
|
 Several really good programming and control specialists haunt CD, but a thread titled "motor failure" might not attract their notice soon. - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Several really good programming and control specialists haunt CD, but a thread titled "motor failure" might not attract their notice soon. - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
12-01-2005, 01:29
|
|||
|
|||
|
Re: Tetra Parts
You should see if you can find LDPE (Low Density Polyethylene) which is what FIRST used. It is a very flexible material, but pretty tough.
I just cut up a whole bunch of the clovers using a power scroll saw. A bandsaw would also do a fine job. Beats the heck out of $4 a pop from IFI. Kevin 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Parts Swap | Jeff Waegelin | CD Forum Support | 10 | 30-08-2006 08:23 |
| **FIRST EMAIL**/Missing Parts Orders Due January 13th, 2005! | Goobergunch | FIRST E-Mail Blast Archive | 0 | 10-01-2005 12:37 |
| PLEASE RESPOND: NRLB & Spare Parts at Nats | ngreen | Championship Event | 12 | 23-04-2004 16:06 |
| Rules on making spare parts fyi | DougHogg | General Forum | 0 | 02-04-2003 16:18 |
Threaded Mode