|
|
|
 I would have bought a bigger box of popcorn and sat up higher in the stands. In the middle. - JaneYoung [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I would have bought a bigger box of popcorn and sat up higher in the stands. In the middle. - JaneYoung [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
14-01-2005, 00:39
|
||||
|
||||
|
Re: Drive Assembly Sprockets are Custom Bored
The transmission output shaft is metric - 16mm dia with a 5mm keyway.
(as taken from the transmission manual found here: http://www.ifirobotics.com/kitbot.shtml in the output shaft drawing spec) Paul, please correct me if I'm wrong. Teams can buy any size sprocket they want (with a bore less than 16mm), rebore it to 16mm and rebroach to 5mm. There is probably a fancy way to broach this keyway, but the simplest way is just to buy a metric broach set. Anyone else have advice? Last edited by JVN : 14-01-2005 at 00:42. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Kit Drive Assembly | Allison K | Kit & Additional Hardware | 5 | 11-01-2005 17:52 |
| [OCCRA]: Drive Motor Sprockets | Occrafan23 | OCCRA Q&A | 1 | 28-09-2004 10:43 |
| [OCCRA]: more drive sprocket qs | greencactus3 | OCCRA Q&A | 1 | 24-09-2004 18:50 |
| Globe gear box | Pat Roche | Motors | 9 | 25-05-2004 22:50 |
| pic: 885 Right-center wheel and drive assembly | CD47-Bot | Robot Showcase | 2 | 30-04-2004 18:27 |
Threaded Mode