Drive Assembly Sprockets are Custom Bored

If a suspicious distrustful atmosphere is created, then a suspicious distrustful reaction will occur. - JaneYoung [more]

		Chief Delphi > Technical > Kit & Additional Hardware
Drive Assembly Sprockets are Custom Bored

Thread Tools

Rate Thread

Display Modes

14-01-2005, 11:33

Joel Glidden Joel Glidden is offline

My heart pumps diesel.

FRC #4293 (Komodo)

Team Role: Engineer

Join Date: Apr 2002

Rookie Year: 2001

Location: Highlands Ranch, CO

Posts: 208

Joel Glidden is a glorious beacon of light

Re: Drive Assembly Sprockets are Custom Bored

You could also turn down the output shafts to 5/8" on your handy dandy lathe. You could also mill a 3/16" keyway on the opposite side of the shaft from the existing 5mm keyway.

-Joel

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Kit Drive Assembly	Allison K	Kit & Additional Hardware	5	11-01-2005 17:52
[OCCRA]: Drive Motor Sprockets	Occrafan23	OCCRA Q&A	1	28-09-2004 10:43
[OCCRA]: more drive sprocket qs	greencactus3	OCCRA Q&A	1	24-09-2004 18:50
Globe gear box	Pat Roche	Motors	9	25-05-2004 22:50
pic: 885 Right-center wheel and drive assembly	CD47-Bot	Robot Showcase	2	30-04-2004 18:27

All times are GMT -5. The time now is 06:37.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.