|
|
|
 At this point in build season, I'm thinking that whatever type we can get built and working is the best type, by far! - MrForbes [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| At this point in build season, I'm thinking that whatever type we can get built and working is the best type, by far! - MrForbes [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
About Robot Power Distribution Diagram
How do you connect multiple CIM motors to the Robot Controller
from my point of view of the diagram it seems that to connect the motors from one victor speed controller is it possible to use just 1 speed controller for multiple CIM motors or do you need multiple speed controllers? -if I need more speed controllers where will I connect the speed controllers to? thank you! Any help will be appreciated! PS. is any of the diagrams(ie. speed controller, Robot contoller,etc.) on the Robot Power Distribution diagram available to make a custom diagram? thanks again for any help!  |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Winning Robot or Quality Robot? | Eric Bareiss | General Forum | 30 | 09-02-2006 13:19 |
| How much planning goes into your robot? | Jnadke | General Forum | 41 | 29-01-2006 21:29 |
| A Question on Sportsmanship | Steve M | General Forum | 31 | 25-05-2004 23:52 |
| Operator Interface power ISSUE | kacz100 | Technical Discussion | 11 | 27-02-2004 13:46 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |
Threaded Mode