|
|
|
 Being inspired is a lot like learning, not everybody does it the same way. - Jay Trzaskos [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Being inspired is a lot like learning, not everybody does it the same way. - Jay Trzaskos [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: Question about drill transmission specs
I was asking for info on the bosch drill transmissions provided in the 2004 kop. In the transmission, the pinion gear interacts with 5 14t planetary gears. A gear above it, that has pins that these planetary gears spin on has a hole in it that is keyed. I wanted to know the diameter of this hole, since it is a circular keyway, what the specs are on the keyway, if that is possible. Again, thanks for your help.
|
|
#2
17-01-2005, 23:58
|
|||
|
|||
|
Re: Question about drill transmission specs
I'm betting some nice calipers would do the trick. Do you have any? If so, just measure it.
|
|
#3
18-01-2005, 00:14
|
|||||
|
|||||
|
Re: Question about drill transmission specs
it's not so much the diameter. The problem is that I also need to know the specs on that key way and haven't a clue about how to find that out because it's a circular keyway (I did use calpers and my reading was 6 mm for the diameter, but it didn't seem real solid on 6 so I was questioning it)
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OCCRA]: drill transmission | greencactus3 | OCCRA | 4 | 14-10-2004 22:33 |
| [OCCRA]: [OCCRA] drill transmission | greencactus3 | OCCRA Q&A | 1 | 11-10-2004 19:31 |
| Need info on gears inside drill transmission. | sanddrag | Motors | 7 | 14-04-2004 11:01 |
| CAD of Bosch drill motor transmission? | Crazy | Inventor | 7 | 21-01-2004 12:03 |
| BOSCH Drill Transmission Assembly | archiver | 2001 | 2 | 23-06-2002 22:08 |
Hybrid Mode
