|
|
|
 Wisdom is knowing the difference between "the way to do things" and "the right way to do things." Just because an action may be physically possible does not mean that it is smart to do. - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
MISSING VIRTUAL KIT PARTS!!!
 My team has downloaded the virtual kit and we cannot find any of the pneumatics except for the connecters. We are trying to use pistons and have looked everywhere. If there are any new additions to the library, please tell us where to get them. |
|
#2
13-01-2005, 20:08
|
||||
|
||||
|
Re: MISSING VIRTUAL KIT PARTS!!!
I don't about any virtual kits... but if you mean from FIRSTCADLibrary.com, there were two pneumatic cylinder downloads on the site.
Well, apparently FIRSTCADLibrary.com is down due to the lack of bandwith, but you're in luck. I found two pneumatic cylinders on my computer. They are the 3/4-inch bore and 2-inch bore downloads. I uploaded them to a Geocities account. Get them here: 3/4-inch bore 2-inch bore NOTE: After extracting the .ZIP files, the Inventor files are in .IGS format |
|
#3
14-01-2005, 13:37
|
|||
|
|||
|
Re: MISSING VIRTUAL KIT PARTS!!!
Since it is the First release, we can likely expect more releases of other pieces. When? Just check daily, plus if you need these pieces now then make them in Inventor, if you can wait for their release (Whenever that might be) then wait.
I believe there was an Email address in the Zip on how to contact them in case of questions. |
|
#4
20-01-2005, 15:26
|
|||||
|
|||||
|
Re: MISSING VIRTUAL KIT PARTS!!!
http://www.bimba.com/cad/new3dfrmst.htm
Bimba's website will generate any piston you're looking for in Cad! |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Virtual Kit of Parts? | Ianworld | Inventor | 22 | 26-01-2005 09:11 |
| Anyone missing as many parts as we are? | Drew Hopman | Technical Discussion | 4 | 19-01-2004 19:06 |
| Rules on making spare parts fyi | DougHogg | General Forum | 0 | 02-04-2003 16:18 |
| missing kit parts | Stephen Kowski | Kit & Additional Hardware | 57 | 22-01-2003 12:27 |
| Inventor and Virtual Kit of Parts | Torchin | Inventor | 1 | 09-01-2002 09:59 |
Linear Mode
