|
|
|
 Making even just one person feel safe and included in FIRST is how we know that we have succeeded. - Mr_Moko [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Making even just one person feel safe and included in FIRST is how we know that we have succeeded. - Mr_Moko [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Problem running compiled code
When we make any change to the default source code, compile it, and upload it to the robot, it will not run. The robot controller just hangs, with lights flickering on and off. The upload seems to go properly, with the correct acknowledgement messages etc.
When we upload the unmodified default code, everything works properly (except that the robot complains that it cannot find the camera), so the connection between the computer and robot works just fine. We are using the latest version of the C18 compiler. Any ideas? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Kevin Watson's Kick-off Demo Code! | Mr. Lim | Programming | 27 | 22-01-2005 03:38 |
| Some Blank Code That you Know works | chantilly_team | Programming | 5 | 18-01-2005 22:00 |
| Strange IR sensor movement with default tracker code | wun | Programming | 5 | 19-03-2004 10:51 |
| One final fairly massive problem with the code... | authgeek1218 | Programming | 5 | 19-02-2003 16:51 |
| Ok one problem | cantwell03 | Programming | 3 | 13-02-2003 07:28 |
Threaded Mode