|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||
|
|||
|
Re: How to use multi-positioning?
There were a number of good posts on this subject last year. You hook up a solenoid to your actuator as though you were going to just go with two positions. You then plumb the exhausts of this solenoid together and feed that combined exhaust to another solenoid. When you want to stop the actuator at a mid position position you close the second solenoid and that pressurizes the exahust side and stops the actuator in mid stroke.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Autonomous Positioning | SteveO | Programming | 9 | 16-01-2005 18:14 |
| White Paper Discuss: Code and Walkthrough for Global Positioning System using IR Sensors | CD47-Bot | Extra Discussion | 2 | 20-05-2004 21:22 |
| banner sensor positioning and times | bob1million | Programming | 4 | 16-02-2004 13:40 |
| Wheel slippage w/ positioning systems | Jay Lundy | Electrical | 3 | 12-12-2003 03:08 |
| multi rotational potentiometers | jdawson | Electrical | 8 | 27-01-2003 08:12 |