|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: How to use multi-positioning?
So has anyone mad much luck using the magnetic switch things to make the cylinder stop somewhere along the length? Like we are looking at using such a system for autonomous stuff, and I would like to have two pre programmed stop points along the cylinder so we would essentially have four different positions we could put it in.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Autonomous Positioning | SteveO | Programming | 9 | 16-01-2005 18:14 |
| White Paper Discuss: Code and Walkthrough for Global Positioning System using IR Sensors | CD47-Bot | Extra Discussion | 2 | 20-05-2004 21:22 |
| banner sensor positioning and times | bob1million | Programming | 4 | 16-02-2004 13:40 |
| Wheel slippage w/ positioning systems | Jay Lundy | Electrical | 3 | 12-12-2003 03:08 |
| multi rotational potentiometers | jdawson | Electrical | 8 | 27-01-2003 08:12 |