Modifying CIMs to implode?

[ahecht]

To answer the above post, let me cite R31, which says nothing about the integrity of the motors:

1. 1. It is acceptable to modify the mounting brackets and/or other structural parts of the motors (output shaft, housing, etc.) as long as the electrical system is not modified and the integral mechanical system of the moving parts (bearings, bushings, worm gear output stages, etc.) is not changed or removed.

We are modifying the housing, not integral moving parts.

Originally Posted by Andy A.

I agreed that it was legal, but wasn't sure if it was worth it. I forgot how much weight they lost with this.

The weight loss was not terribly significant (around .1 pounds), but it helps with heat dissipation. Just make sure to put some clearcoat or paint on them after turning them down, as unprotected steel will rust.