|
|
|
 Ideally, you'll make sure your drive system can handle some Irritating Failures without them becoming Paralyzing Failures. - Billfred [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Ideally, you'll make sure your drive system can handle some Irritating Failures without them becoming Paralyzing Failures. - Billfred [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Need help designing keyway in gear
It'd be a pretty fair assumption to say that ANSI keyways (3/32 in this case) are designed to for nearly maxmimum torque transferring power (not maximum because they are designed so the key breaks first when everything is the same material). You can do some pretty simple shear strength calculations to figure out exactly how much torque you can transfer. I did half of it for you just because I was curious
 13 Nm = 9.6 ft-lb 9.6 * 12 = 115 in-lb 115 / ((3/8)/2) = 614 lb of force shearing the key Last edited by Max Lobovsky : 25-01-2005 at 22:27. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gears | Michael Leicht | Inventor | 12 | 16-09-2004 10:52 |
| Reverse Gear | FizMan | Technical Discussion | 12 | 26-04-2004 01:29 |
| Thunder Chicken CCT | Simon G | Motors | 4 | 03-01-2003 13:18 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Drivetrain Help | Jordan | Technical Discussion | 16 | 02-12-2001 12:14 |
Hybrid Mode
