|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
|
|||||
|
|||||
|
Re: Using Custom Inputs on the Controller Board
Unless you put in a specific check, the software doesn't care about enabled vs. disabled. The only difference is whether or not the RC pwm and relay outputs are activated.
Autonomous vs. manual is another story. If you put code in the autonomous section, it will only run if autonomous mode is commanded (by grounding the "autonomous" pin on the competition port). I'm not sure if the auton_mode flag is overriden by the "disable" pin or not. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help On Coding 2K1 Controller | GregTheGreat | Programming | 9 | 05-12-2003 18:35 |
| serious problem found - robot controller resets when jarred! | KenWittlief | Electrical | 23 | 19-03-2003 13:30 |
| Custom Mod Controller. | Josh Hambright | Electrical | 9 | 17-01-2003 08:05 |