Connecting Switch to RC

28-01-2005, 15:56

Mr. Steve

No relation to Mrs. Steve

#1626 (Falcon Robotics)

Join Date: Nov 2004

Rookie Year: 2005

Location: NJ

Posts: 34

Mr. Steve is an unknown quantity at this point

Connecting Switch to RC

Does anybody have any information regarding hooking a switch (ex: Radio Shack #275-663)directly to the robot controller. I notice that switch has 3 pins, but I'm not sure which wire would go to which. What about if the switch/button only has two wires? Where would the ground go?

I'm assuming they would plug into the the Digital Ins/Outs, but I'm not sure.

Any Info would be appreciated.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
LEDs in switch box.	ZZII 527	Electrical	5	06-03-2004 19:39
Digital Inputs interfering with each other	Bongle	Programming	8	23-02-2004 11:18
OI jog switch	Natedude	Control System	4	22-02-2004 17:13
connecting pressure switch	kingpin3787	Pneumatics	2	19-02-2004 21:01
Using a switch before autonomous operation	KZos550	Programming	11	04-02-2003 19:12

All times are GMT -5. The time now is 20:32.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.