|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||||
|
||||||
|
Re: Left Handed Joystick
Quote:
Through work I have access to an SLS (Selective Laser Sintering) machine. I can get 1 or 2 of something done for free by putting it in the extra space around the money jobs. If I have to build a lot of something, but not enough to make injection molding profitable, then I can rent time at a commercial service. For large numbers of small parts SLS can be affordable on a per part basis, if the parts are packed tightly. While the calipers and 3d Studio approach might produce a usable product, it would take a lot of work to get it right. A laser scan like phrontist mentioned takes minutes and all of the holes at strange angles will be properly positioned. Why do it the hard way if you don't have too? |
|
#2
|
|||
|
|||
|
Re: Left Handed Joystick
Quickshot makes some pretty nice lefty gameport joysticks. I live in canada, so its a huge pain getting them up here, but you shouldnet have any trouble. You are looking for the GenX series (I think thats where I remember seeing them). linky
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| trentonDrive.c: our joystick/wheel drive code | gnormhurst | Programming | 16 | 03-02-2005 14:40 |
| Using an FRC with the RCX? | Astronouth7303 | Programming | 21 | 15-04-2004 14:14 |
| Changing 1 joystick code to 2 (rookie team) | Brawler006 | Programming | 5 | 20-02-2004 17:00 |
| problem with joystick buttons (top left one) | Richomundo | Programming | 5 | 15-02-2004 17:16 |
| robot goes haywire with the one joystick default code | Miles | Programming | 7 | 24-01-2003 14:58 |