|
|
|
 I don't think it's that big of a deal if FIRST makes a few mistakes or cuts back every now and then. Personally, I'm just glad I have the opportunity to be in this program. - Crop-Circles [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Pins to insert into PWM Header on Camera
What type of pins should I use to connect to the two PWM headers on the camera (rs232, power). I know i can just use regular PWM cables but I want to have all cables going out in one place so there are only two holes in the cover. I tried taking the cables/pins out of the PWM cables but once you bend them over so the cover fits they become very brittle and break. I have already tried it with 2 PWM's and they both broke.
Team 447 did it somehow and I was wondering how. http://www.chiefdelphi.com/forums/sh...threadid=32884 |
|
#2
29-01-2005, 02:06
|
||||
|
||||
|
Re: Pins to insert into PWM Header on Camera
Well, the simple method would be to cut PWM cables, and solder the ends to a connector, if you wanted a result similar to 447's. You don't have to use PWM cables, though; any 3-pin header will work.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Scripting Setup and the Camera + Serial Port Drivers | CJO | Programming | 22 | 11-01-2006 17:42 |
| Unresponsive camera | neilsonster | Programming | 9 | 17-02-2005 08:51 |
| FYI about using PWM 13-16 with interrupts | cabbagekid2 | Programming | 6 | 22-01-2005 00:54 |
| CMUCam2 Camera Code - Are important parts commented out? | Mr. Lim | Programming | 4 | 14-01-2005 12:11 |
| [ECDU]: CHAT-7/19 | Corey Balint | FIRST-related Organizations | 5 | 19-07-2004 23:44 |
Linear Mode
