Custom LED outputs

[JoelP]

hi, rookie programmer here

In the IFI operator interface manual, it says that port 1 and port 3 have robot feedback LED pins so you can display feedback on a custom control box. I would like to do that on a custom box along with some switches, however, it also says that these feedback LED pins just copy the LEDs on the Operator Interface. This seems a little pointless to show the same information in 2 places. I would like LEDs on the control box to display a different set of informations, sooo
in short, is there a way to map out the pins on the ports to control different feedback LEDs that you could add to the code? eg. Relay3_red, Relay3_green?

btw, i'm not sure if this is against the rules or anything