pic: Linear bearing + mount

Alex1072 · #1 31-01-2005, 19:18

Rickertsen2 · #2 31-01-2005, 19:20

Where did you get those and how much did they cost? All of the linear bearings that i have seen like that are obscenely expensive.

Alex1072 · #3 01-02-2005, 23:22

Quote:

Originally Posted by Rickertsen2

Where did you get those and how much did they cost? All of the linear bearings that i have seen like that are obscenely expensive.

=) Donated by the company =)

edit: aprox $700 value.

Mark Pettit · #4 02-02-2005, 09:55

How do you go about justifying the cost over the $400 limit?
I thought that even donated parts had to come in under the $400 value.
See rules 5.3.4.3 and 5.3.4.4.

Max Lobovsky · #5 02-02-2005, 10:05

Perhaps the parts (bearing shaft and sliders) each are less than 400?

Mark Pettit · #6 02-02-2005, 10:16

Quote:

Originally Posted by Max Lobovsky

Perhaps the parts (bearing shaft and sliders) each are less than 400?

That'll work, then!

whakojacko · #7 02-02-2005, 11:13

we have 6 bearings, each bearing/mount is about $120 i think

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
bearing help	jimfortytwo	Technical Discussion	9	01-05-2004 06:20
pic: 870 Motor Mount	CD47-Bot	Robot Showcase	9	27-04-2004 11:55
In need of plastic drill mount	jjdebner	General Forum	4	19-02-2004 20:56
TCP/IP on a PIC	Venkatesh	Electrical	1	18-11-2003 21:00
Need A 0.75" ID bearing .DWG	Tytus Gerrish	Inventor	6	22-10-2003 11:23