|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||
|
|||
|
Re: 2-sided faces?
How could I give my cone thickness as you suggested? That seems like the best option, but I don't know how I would do it. Keep in mind that I am relatively new to 3d studio.
Thank you! -jake |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to cut flat sided holes for Globe and Door motor | Max Lobovsky | Motors | 8 | 13-01-2005 14:09 |
| inventor to 3D faces format | Ken Ginger | Inventor | 0 | 27-12-2004 20:19 |
| two sided timing belt | archiver | 2001 | 3 | 23-06-2002 22:34 |
| Dual Sided Timing Belts | Lachuck894 | Technical Discussion | 9 | 14-01-2002 10:10 |