|
|
|
 Welcome to FIRST, the place where you can be competitive in a team. Here people can learn more in one year of FIRST than in four years of high school. - dude__hi [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Welcome to FIRST, the place where you can be competitive in a team. Here people can learn more in one year of FIRST than in four years of high school. - dude__hi [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
04-02-2005, 08:15
|
||||
|
||||
|
Re: Modifying Parker Cylinder
<R85> allows you to remove the pin but you are not allowed to "file, machine or abrasively remove any part of an air cylinder".
So you cannot enlarge or machine for a key. You can bush if the original hole is larger than the motor shaft. You cannot machine the hole larger if it is too small. Pressing the cylinder onto the shaft 'as is' could fall under the "abrasively remove" clause. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mulit-postioning with pnuematics this year? | KenWittlief | Pneumatics | 101 | 01-02-2005 21:54 |
| Making a series of spaced holes around a cylinder in inventor | James114 | Inventor | 13 | 21-11-2004 18:44 |
| Need Inventor model 3/4" Bore Cylinder Quick | sanddrag | Inventor | 1 | 05-04-2004 00:40 |
| Is 'using a smaller cylinder' really that easy?? | mjt902 | Pneumatics | 4 | 29-01-2003 16:13 |
| Stopping a Piston... | Dan 550 | Technical Discussion | 7 | 02-02-2002 11:36 |
Threaded Mode