|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Burning the FP's
gear that devil down... even if it worked with the origional 4:1 reduction, that arm is flying through the air, and when the arm+robot+tetra all runs into a brick wall, thats a lot of intertia waaaaay up in the air... we learned the hard way last year what inertia does to an arm, and what happens when intertia takes over..not a pretty sight.. the tip of our arm, fully extended, will move no faster than 16in/sec..
good luck j |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How slow is too slow? | Joe Ross | Rules/Strategy | 23 | 12-10-2004 20:23 |
| Programming port burning hot | Joe Ross | Control System | 5 | 02-03-2004 09:47 |
| FP burning out | Max Lobovsky | Motors | 6 | 24-02-2004 07:52 |
| PWM and burning out motors | patrickrd | Technical Discussion | 7 | 19-06-2003 15:30 |
| Burning rumors | archiver | 1999 | 5 | 23-06-2002 21:58 |