Team 804 Electronics (completeness)

[scifi3018]

First is the Board in the clean, tidy state (read: not hooked up) acually taken after todays work... but you dont know that
For some explanation, starting top right, clockwise is: 2 Spike Modules, 2 PWMs, CPU, Power Swith, Empty Space, 2 PWMs, 2 more Spikes, Breaker Board, The 2 wires going off the top are the 12v battery, and the 7.2 volt backup Battery respectivley


Next (acually before last (if you understand my logic, raise a hand)) is the board hooked up and in use


Another


A pic of the Wiring Job, all wires come out from the Breaker Board, then go under it to the center, than out to werever needed

A small control switch panel with (left to right) 3 switches to select what progrma to turn on the robot, remote reset/power butotn, remote program button


Next is some cool stuff, the camera that we have tested its color trakcing, i made the case, doest it look sexy?


And now last but not least, the modding part...

What i want to do is drill 5mm holes and put some leds into them to iluminate them, i have 2 3000mcd red LEDs, is this enough to get decent lighitng around the edge if i have one on front, back? also how can i finish the edge of the board to be polished, will that make the leds more effective?

Any opinions, comments, questions, help is grealty appreciated