|
|
|
 Just be yourself, be honest, and most importantly, be present. The best role models are the ones you can relate to. - Jessica Boucher [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Just be yourself, be honest, and most importantly, be present. The best role models are the ones you can relate to. - Jessica Boucher [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||||
|
||||||
Analog / Digital IO Connectors
What methods have teams used for physically connecting to the Analog and Digital ports on the RC?
I seem to remember a drawing that showed the pin spacing, but I can't find it at IFI. I also remember some discussion on CD at one point, but I can't find that either... maybe I'm just having one of those days. (I don't have immediate access to an RC or I would measure... ) Any tips would be appreciated -- Thanks! Aidan |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Digital Caliper as a Digital Readout on Small Mill | sanddrag | Technical Discussion | 9 | 13-10-2005 22:51 |
| Dynamic Input/Output Changing | Paolo | Control System | 6 | 23-09-2004 19:09 |
| heres the code. y this not working | omega | Programming | 16 | 31-03-2004 15:18 |
| Why not analog sensors?? | gnormhurst | Programming | 16 | 07-03-2004 16:14 |
| digital i/o connectors | Mercutio | Electrical | 4 | 19-01-2004 19:20 |
Threaded Mode