|
|
|
 You're on a team, weren't you taught Gracious Professionalism? It doesn't only apply to competitions, it applies to the real world. - Zac Schofield [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| You're on a team, weren't you taught Gracious Professionalism? It doesn't only apply to competitions, it applies to the real world. - Zac Schofield [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
ADXRS300EB gyro help
I am wondering if any one can confirm the pins for the evaluation board is pin 1 = power, pin 2 = rate out and pin 8 = ground. I tried using the default code and only change was the gyro selection. I am getting no gyro rate in the terminal.
|
|
#2
08-02-2005, 16:54
|
||||
|
||||
|
Re: ADXRS300EB gyro help
Kevin's default gyro code is set to analog 1 - make sure your gyro is connected to analog 1 unless you have changed it in the code.
|
|
#3
08-02-2005, 17:02
|
|||||
|
|||||
|
Re: ADXRS300EB gyro help
It is. i get a rate sometimes but never higher than five
|
|
#4
08-02-2005, 17:33
|
||||
|
||||
|
Re: ADXRS300EB gyro help
Quote:
-Kevin |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Updated: Example Gyro Interface Code | Kevin Watson | Programming | 2 | 28-03-2005 04:36 |
| Example gyro code released. | Kevin Watson | Programming | 60 | 17-03-2005 18:32 |
| Gyro Troubles | SteveO | Programming | 13 | 30-01-2005 16:46 |
| ADXRS300EB Rate Gyro | rmeenaks | Electrical | 18 | 05-04-2004 22:37 |
| ADXRS300EB Rate Gyro | rmeenaks | Technical Discussion | 0 | 31-03-2004 16:48 |
Linear Mode
