|
|
|
 Even if this is the Rumor Mill, there are behaviors that need to be adhered to. - meaubry [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Even if this is the Rumor Mill, there are behaviors that need to be adhered to. - meaubry [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
09-02-2005, 23:19
|
|||
|
|||
|
Re: van door power question
with a 9 inch diameter tire a direct drive from the van door motors at 70 rpm should be going about 2.7 ft/sec or 1.8 mph, just below walking but right about how fast a robot on the cart should go.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Van door torque curves | Bolotov | Motors | 1 | 05-02-2005 09:10 |
| Motor Torque Question | troy_573 | Motors | 13 | 22-01-2005 23:53 |
| Question of the Week!!! (7/19/04) | Andy Grady | General Forum | 23 | 23-07-2004 13:21 |
| Question of the Week!!! (6/14/04) | Andy Grady | General Forum | 23 | 01-07-2004 15:54 |
| van door question | archiver | 2000 | 1 | 23-06-2002 22:27 |
Threaded Mode