Accelerometer and hall effect sensors

brownster · #1 13-02-2005, 10:58

I'm kinda new to this programming thing so i have some questions. I downloaded Kevins code to use during autonomous mode on our bot. However we just don't have the budget to buy gyros or encoders. So i was wondering if its possible to use the Accelerometer and hall effect sensors provided with Kevins code to run autonomous?...if someone could set me straight on this that would be appreciated.

jgannon · #2 13-02-2005, 13:36

Quote:

Originally Posted by brownster

I'm kinda new to this programming thing so i have some questions. I downloaded Kevins code to use during autonomous mode on our bot. However we just don't have the budget to buy gyros or encoders. So i was wondering if its possible to use the Accelerometer and hall effect sensors provided with Kevins code to run autonomous?...if someone could set me straight on this that would be appreciated.

I'm not as familiar with Kevin's navigation code as I ought be, but I know that you can use his encoder library with the Hall Effect sensors.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Where to place Hall Effect Sensors.	Moloch	Electrical	10	11-02-2005 16:47
Hall Effect Sensor.	Nixterrimus	Electrical	77	29-01-2005 10:48
Are we given sufficient sensors in the kit?	Nucks	Technical Discussion	16	11-01-2005 22:07