Four motor control - Chief Delphi

I was very concerned about this thread. Then I realized you were talking about a computer. - Taylor [more]

		Chief Delphi > Technical > Programming
Four motor control

Thread Tools

Rate Thread

Display Modes

14-02-2005, 19:55

judson

Registered User

#0824

Join Date: Jan 2005

Location: Seattle

Posts: 3

judson is an unknown quantity at this point

Four motor control

Hello all!

I am trying to figure out if the default code supports four motor control. I have a pair of CIM motors for each sides of the robot's transmission. I have played around for a bit with things trying to get all four running on the default code.

So far I can only get two at a time running on PWM 15 and 16. Does anyone have any tips? I cannot even see where in the default code this would be edited.

Thanks.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:00.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.