|
|
|
 Don't be in a rush to build a robot until you know what robot it is you need to build. - Chris Fultz [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't be in a rush to build a robot until you know what robot it is you need to build. - Chris Fultz [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Quick 3DSM problem
Ok this is driving me nuts! Some how I clicked something so that my regular transform gizmo got turned into thin grey lines for each axis, depending on which transform I select one or two of these axis are colored red and I can only transform on those axis. I can't figure out how to change which axis is constrained and I can't figure out how to get back to the regular cool looking gizmo with nifty yellow highlighting. I am using max7 anyone know what is wrong and how to go back to normal?
|
|
#2
15-02-2005, 20:45
|
|||
|
|||
|
Re: Quick 3DSM problem
Press X
 This is probably in the wrong section, but I'll help  |
|
#3
16-02-2005, 13:29
|
||||
|
||||
|
Re: Quick 3DSM problem
Thanks bunches, that is exactly what I needed. I still got a lot done by switching views and then doing the transforms, but it was really annoying.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem w/Mesh | Kevin Thorp | 3D Animation and Competition | 4 | 17-02-2005 23:04 |
| Programming Problem: Extremely Frustrating | chantilly_team | Programming | 19 | 12-02-2005 23:00 |
| Physics Problem | Venkatesh | Math and Science | 13 | 30-11-2004 20:30 |
| The problem with scouting... | archiver | 2001 | 10 | 23-06-2002 23:49 |
| Major problem with chipphua motors | aka Scott White | Motors | 18 | 19-03-2002 19:44 |
Linear Mode
