|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
||||
|
||||
|
Re: How do you hook up the camera?
if i dont hook up the ttl port and the pwm cord to the rc controller then i dont get any pwer, why is this?
|
|
#17
|
|||||
|
|||||
|
Re: How do you hook up the camera?
Quote:
The PWM output power is only supplied by the small backup battery attached to the RC. Only the center red wire of the PWM cable is actually used. The camera doesn't care what the PWM is set to in the code. |
|
#18
|
|||
|
|||
|
Re: How do you hook up the camera?
Yea i noticed that too, the cam wouldnt work without the battery, i read over the manual again to see if it provided that we needed anything else, and there it was... you need the back up. Hooked it up and the lights went on I was happy
.Couldnt have done it without you Mark |
|
#19
|
||||
|
||||
|
Re: How do you hook up the camera?
i realized that i had put the pwm cord backwards and thats why it wasnt getting any power. lol.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Scripting Setup and the Camera + Serial Port Drivers | CJO | Programming | 22 | 11-01-2006 17:42 |
| Unresponsive camera | neilsonster | Programming | 9 | 17-02-2005 08:51 |
| Kevin Watson's Kick-off Demo Code! | Mr. Lim | Programming | 27 | 22-01-2005 03:38 |
| CMUCam2 Camera Code - Are important parts commented out? | Mr. Lim | Programming | 4 | 14-01-2005 12:11 |
| YMTC: Super Duper Hook! | Natchez | You Make The Call | 7 | 14-12-2004 20:50 |