A little hardware help

Fixen · #1 16-02-2005, 18:14

When I turn on the camera (with everything plugged in), there is only one green LED, instead of the green and red LEDs together as described in the manual. In addition, the CMUCam GUI isn't detecting my camera. Can someone tell me what's going on?

SpeakerSilenced · #2 16-02-2005, 19:03

That happened to me too recently, I was able to get image fine, then we started calibrating it, had to unhook it for a while. And then I couldnt access it anymore

Fixen · #3 17-02-2005, 00:19

Same thing? I tried calibrating it, didn't get anything, unhooked it and checked out the manual, slapped myself for not clicking the "grab image" button, tried again, and spent the next hour afterwards frowning over this crazy problem.

I did turn off all the power in my robot before unplugging it, so I'm sure I didn't short out anything.

SpeakerSilenced · #4 17-02-2005, 06:35

My program refuses to see the camera... maybe its my computer

Fixen · #5 17-02-2005, 16:36

Oh! Now it picks up the camera! And it doesn't grab a frame! And the camera stops again!

...this little devil is a real pain.

SpeakerSilenced · #6 17-02-2005, 16:49

a similar problem happened on another thread, im going to do what they said and rewrite the mastercode and rewrite the usercode too

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gracious Professionalism at your local hardware store	pi_guy578	General Forum	20	18-01-2005 17:05
Center Goal Hardware	coastertux	Kit & Additional Hardware	8	14-01-2005 15:59
Center goal hardware specs	CSWilken	Technical Discussion	0	13-01-2005 03:26
Additional hardware list	archiver	2000	5	23-06-2002 22:54
Additional Hardware list confusion	archiver	2001	4	23-06-2002 22:29