diameter of transmission output shaft

This is going to be leet. Or something like that. I can't wait. - Billfred [more]

		Chief Delphi > Technical > Electrical
diameter of transmission output shaft

Thread Tools

Rate Thread

Display Modes

17-02-2005, 17:05

JVN

@JohnVNeun

AKA: John Vielkind-Neun

FRC #0148 (Robowranglers)

Team Role: Engineer

Join Date: May 2001

Rookie Year: 2000

Location: Greenville, Tx

Posts: 3,159

Re: diameter of transmission output shaft

Well..

You can:

Whip out some calipers and measure it.
Search this site, because the question has been asked many times.
Search the Transmission documentation, because it is shown there.

Any one of these would yield the correct answer:
It is 16mm, with a 5mm keyway.

__________________
In the interest of full disclosure: I work for VEX Robotics a subsidiary of Innovation First International (IFI) Crown Supplier & Proud Supporter of FIRST

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with 5/8 in. shaft in this years kit	echos	Kit & Additional Hardware	5	14-01-2004 21:21
Cutting the output shaft	Kevin A	Technical Discussion	2	18-02-2003 01:47
Hint #1 for Ken Leung	Shawn60	General Forum	35	11-02-2003 08:04
Securing hex shaft to drill output	D. Gregory	Technical Discussion	6	24-01-2003 14:05
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32

All times are GMT -5. The time now is 08:49.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.