|
|
|
 Well, there goes our bare aluminum corner tracking full field navigation system... - Whippet [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Well, there goes our bare aluminum corner tracking full field navigation system... - Whippet [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
23-02-2005, 02:14
|
||||
|
||||
|
Re: victors spikes and pwm cables
We had problems with the PWM cables making decent connections to the RC.
Hot glue? Ugh. I suppose that'd work, but only as a last resort. Just use a tiny bit (just enough to be able to slice with an exacto knife in the event of a problem). Plugging the cables in was MUCH harder this year .. because IFI shipped em with those little plastic tabs where the cable plugs in. Its a simple fix with a small knife, but cutting into those little $120 blocks of plastic scares the crud out of me. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FYI about using PWM 13-16 with interrupts | cabbagekid2 | Programming | 6 | 22-01-2005 00:54 |
| Using an Operator Interface with the 2004 EDU RC wirelessly | Dave Flowerday | Robotics Education and Curriculum | 34 | 19-04-2004 19:06 |
| In need of PWM Cables! SOON! | Travis Covington | Electrical | 2 | 19-02-2004 20:55 |
| Can we shorten the PWM cables? | RAWdealer59 | Electrical | 3 | 18-02-2003 15:49 |
| Loss of signal in PWM cables. | archiver | 2001 | 6 | 23-06-2002 23:29 |
Threaded Mode