|
|
|
 Seeing a bunch of teams from Indiana and probably Michagin competing at the same time.... If I wanted to see that, I'd just go to the Championship in Atlanta. :yikes: - Barry Bonzack [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
23-02-2005, 09:42
|
||||
|
||||
|
Re: pic: Rachel climbs a tree... 1018
Actually the arm (the horizontal portion) only weighs about 16 lbs. (including the hook and the motor) We don't intend to drive around much with it all the way up in the air. The whole robot weighs in at slighty less than 119 lbs.
The tower and the drive train are NBD... (Nothing but Dewalts...) Chip motors with Dewalt transmissions... We used a globe motor and a rack and pinion system to move the tower arm... I believe that the entire robot is simple but quite elegant in its design approach. thanks B Last edited by Bob Steele : 23-02-2005 at 10:04. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Devils' Tower - 1018 | Bob Steele | Robot Showcase | 14 | 22-02-2005 19:08 |
| pic: Canadian Family Tree | CD47-Bot | Extra Discussion | 2 | 09-05-2004 00:16 |
| pic: 1018 Final Config. | CD47-Bot | Robot Showcase | 17 | 24-02-2004 22:10 |
| pic: 1018 OmniWheels - 1st generation | CD47-Bot | Robot Showcase | 7 | 19-02-2004 16:42 |
| pic: 1018 - Teaser #1 | CD47-Bot | Robot Showcase | 3 | 19-02-2004 16:21 |
Threaded Mode