Go to Post Only a few more days till i get to see her again! This is sad you would think I was talking about a chick... no wonder my gf gets jealous. XD - sportzkrazzy [more]
Home
Go Back   Chief Delphi > Technical > Electrical
CD-Media   CD-Spy  
portal register members calendar search Today's Posts Mark Forums Read FAQ rules

 
 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
  #3   Spotlight this post!  
Unread 25-02-2005, 22:35
ten3brousone's Avatar
ten3brousone ten3brousone is offline
Kurayami o Samayou
None #1160
Team Role: Programmer
 
Join Date: Dec 2004
Location: San Marino
Posts: 32
ten3brousone is an unknown quantity at this point
Re: Wiring Banner sensors

Quote:
Originally Posted by Bduggan04
There's no blue wire on your sensor? The correct connection for the banner sensors from 2003 is:

brown wire (+12V) is connected to a 20A breaker on the breaker panel

blue wire - ground on breaker panel (not the RC)

The signal can be configured one of two ways. If the black wire on the sensor is connected to the digital input Signal pin (White PWM wire), the default value is 0 (open). If the white wire on the sensor is connected to the signal pin, the value read will be 1 (closed).

You probably need to adjust the gain on the sensor. There is a little variable resistor on the side of the sensor that can be adjusted with a screwdriver. Use the light on the sensor to figure out if the sensor is reading the wheel correctly. If the light is on it is seeing a white. If it is off it is seeing black. If the light doesn't change when you move the wheel, adjust the gain on the sensor.

Adjusting the sensors is a a guess-and-check process. This will most likely solve your problem, although you may have it wired incorrectly. Check the wiring as I described above.


sorry yeah the black i had was blue sorry, i had a B on my pencil diagram and didnt post about it till couple days later so i assumed it was black. mm and the light you were refering to, we have it close by default so when it hits white lines it should be 0? and the light you were refering to its the actual red light that emits from the banner sensor or is it on the side of the sensor
__________________
-Rookie plz bear with me thanks!
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Wiring Banner Sensors ten3brousone Electrical 1 17-02-2005 03:16
Banner Sensors Padfoot Black Electrical 6 06-04-2004 10:06
Current sensors wiring zainali Electrical 5 13-02-2004 00:39
wiring diagram for light sensors??? pagemauck Control System 1 21-01-2004 16:32
banner sensors edomus General Forum 7 20-11-2003 19:43


All times are GMT -5. The time now is 06:55.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi