"Load Bearing Surface" - Chief Delphi

I'm totally hooked on reffing now and will be volunteering in the future because of [Beach Blitz]. - Ali Ahmed [more]

		Chief Delphi > Competition > Rules/Strategy
"Load Bearing Surface"

Thread Tools

Rate Thread

Display Modes

#14

26-02-2005, 15:47

Covey41

Registered User

no team

Team Role: Engineer

Join Date: Dec 2004

Rookie Year: 1996

Location: New York, NY

Posts: 58

Re: "Load Bearing Surface"

Guy's,

Give up!! After reading Jason's reply it is obvious that FIRST is not going to change the rule. It's going to stay the same as it was on 11JAN05. You must "touch" the loading zone triangle.

I would also question the integrity of any Ref who would not follow FIRST's instructions on the rules.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ratchet/slip bearing?	Ianworld	Technical Discussion	6	20-01-2005 13:04
Looking for 1/2" id flanged bearing .25" thick or less (with flange)	Travis Covington	Technical Discussion	17	12-12-2004 21:26
bearing help	jimfortytwo	Technical Discussion	9	01-05-2004 06:20
Need A 0.75" ID bearing .DWG	Tytus Gerrish	Inventor	6	22-10-2003 11:23
Bearing support - Official	Mike Martus	OCCRA	0	24-09-2002 05:26

All times are GMT -5. The time now is 18:38.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.