Machine Shop "Accidents"

[Rombus]

Here are my stories:
1. Soldering iron, No matter what i do with a soldering iron, if somehow get burned every time i build a circuit, Nothing major, just a common thing for me, I’m getting better at it

2. Ive blown my share of components, funniest one was when I was playing around with an old electronic keyboard, i was powering it off of a variable power supply, and I screwed up the voltage setting, it worked great for about 30 seconds, then it sounded like a gunshot went off, one of the caps blew and left a huge dent where it hit the outside of the case.

3. Most recent with a machine tool: I was using a drill press to drill some plexi, and i had a team member on the side of the press to make sure I had the alignment right before drilling, i chucked up the bit, and wanted to see if it was centered before drilling. I turned on the press, and the chuck key I had forgotten to take out made a full revolution then flew off towards my teammate. It didn’t hurt him or anything since the drill was set nice and slow. Made us both laugh, and reminded me not to be so careless.