|
|
|
 If this truly bothers you, you should do something CONSTRUCTIVE about it instead of whining about it - Jaine Perotti [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If this truly bothers you, you should do something CONSTRUCTIVE about it instead of whining about it - Jaine Perotti [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#18
22-03-2005, 16:05
|
||||
|
||||
|
Re: No CIM Motor in 2006?
Personally, i love the FP's They are great for just about everything. I would like to see 12 volt FPs though. 6 volts just isn't enough.
HOWEVER. better then all of that would be a 24 volt system. current is not your friend. low heat, high torque=we all win. I would love to see somthing that deals with sand. it would be quite a challange that most teams have never seen. Perhaps we should have a year where there is alot of manuvering and not much lifting. i would LOVE to see some hovorbots. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Regional in Europe in 2006 | unapiedra | Regional Competitions | 49 | 26-05-2005 00:07 |
| Allowed to use CIM motors from last year? | lphan | Motors | 7 | 26-02-2005 16:49 |
| CIM speed in reverse? | colt527 | Motors | 41 | 06-12-2004 19:09 |
| CIM Motors to pull up Robot | Joe P | Motors | 7 | 11-01-2004 22:27 |
| CIM vs. Drill motor | duckshepherd | Motors | 3 | 15-02-2003 18:36 |
Threaded Mode