Inventor Robovation Wheels

Mike · #1 01-04-2005, 16:58

Does anybody have an inventor file of the foam wheels that come with the Robovation Kit?

Thanks
-Mike

jdiwnab · #2 01-04-2005, 22:48

Quote:

Originally Posted by MikeWasHere05

Does anybody have an inventor file of the foam wheels that come with the Robovation Kit?

Thanks
-Mike

I haven't seen the robovation kit yet. Are they like the ones in the EDU bot stuff ( about 3" diameter, 1" thick, gray, ridges cut into the foam, plastic hub, square shaft about 1/8" thick) ? If they are, then I could make some if you need them. Or you could send me a pic with dimentions and I might be able to make them from that.

Mike · #3 02-04-2005, 10:52

They are the same wheels as the Edubot

jdiwnab · #4 04-04-2005, 22:20

Just so people know, I have made the 2 1/4" wheels. See the pic. email me for it. I don't know the demand for them, so be patient (even if there is no demand)

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Who Likes Wheels?	Rob	Technical Discussion	22	06-05-2004 23:49
Four Wheel, all steering, non-omniwheel, ONE power/motor source drive	FizMan	Technical Discussion	31	27-04-2004 12:12
What do you use for wheels?	Andrew	Technical Discussion	36	08-01-2004 10:20
Lots of Wheels and F = u x N	archiver	2001	17	23-06-2002 23:37
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32