|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#22
|
|||
|
|||
|
Re: BEST Tetra Grabber
***********//**[|]**\\
**********//***[|]***\\ ********\ //****[|]****\\ / <------ actual pick up spot of tetras, *********\\****[|]****// (goes in and out) **********\\***[|]***// ***********\\**[|]**// ************\\[||||]// <----- base goes up and down (5\/\/337) **************[|] **************[|] **********|========| <------ omni drive **********|========| [/left] Hey Purple! How did you obtain the drawings we used to do our machining with? Seriously though, that ASCII drawing is way cool. It was funny how that final design finally came about. We kept adding pieces to the arm until the tetras stopped falling off. I wish I could say we did this crazy analysis using quatum, chaotic, neural, fuzzy, self-organizing, genetic, fractal algorithms to find the optimal angles and sizings. But nope, just until it stop falling off or getting stuck in the robot. Last edited by nic_radford : 06-04-2005 at 09:06. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pittsburgh - Did you like our grabber? Team 188 - The Blizzard | Mr. Lim | Regional Competitions | 21 | 14-03-2005 20:35 |
| This is my Tetra... | GateRunner | Chit-Chat | 8 | 08-03-2005 19:12 |
| pic: Team 1126 Tetra grabber | Alex Cormier | Robot Showcase | 1 | 23-02-2005 12:59 |
| pic: 1156 [Brazil] - Tetra Grabber | Daniel_H | Robot Showcase | 15 | 11-02-2005 17:24 |
| Q/A questions so far.. | AmyPrib | Rules/Strategy | 49 | 28-01-2005 08:39 |