|
|
|
 I hope to be able to say, "WOW, we put a working robot in the crate". - MrForbes [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I hope to be able to say, "WOW, we put a working robot in the crate". - MrForbes [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
07-04-2005, 13:47
|
|||||
|
|||||
|
Re: Online Engineering Tables
EFunda: AISI Type 304
That should be most all you need. Shear modulus could be calculated, but you can probably leave it blank. The tension and compression stresses are defined by you, really. Typically you design to yield as a first iteration. Shear limit can be calculated as well. Emissivity doesn't matter unless you're doing thermal modelling, and even then is highly dependent on surface finish. Condition probably doesn't matter, nor should anything below it. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engineer Survey: Engineering Vs Engineering Technology | D.J. Fluck | General Forum | 16 | 27-06-2012 09:16 |
| Introducing the Driver Strategy Database's Online Database | impulse3D | Rules/Strategy | 17 | 17-03-2005 03:04 |
| Columbia University Engineering | Waynep | General Forum | 5 | 12-04-2004 02:01 |
| Full list of teams & competitions | archiver | 2001 | 14 | 24-06-2002 00:52 |
| Engineering vs. Engineering Technology | archiver | 2000 | 4 | 24-06-2002 00:07 |
Threaded Mode