|
|
|
 I dont think it matters too much what you do, as long as you do something that lets you apply what you're learning in class. - MrForbes [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I dont think it matters too much what you do, as long as you do something that lets you apply what you're learning in class. - MrForbes [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Creative Misuse of Digital IO
I've been reading about how serial communications could be used for Good Things on the robot, and since I haven't figured out quite how to use the TTL/RS232 ports, I thought of writing a serial data transfer thingy for use between two IFI RCs over the Digital I/O ports. So the question is: what happens if I wire a digital IO configured for output directly to one configured for input? Does anything dangerous result? My electronics is a little shaky, so I'm not quite sure whether this might damage the RC.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Digital Caliper as a Digital Readout on Small Mill | sanddrag | Technical Discussion | 9 | 13-10-2005 22:51 |
| Auton digital input | ten3brousone | Programming | 7 | 20-03-2005 22:23 |
| Dynamic Input/Output Changing | Paolo | Control System | 6 | 23-09-2004 19:09 |
| heres the code. y this not working | omega | Programming | 16 | 31-03-2004 15:18 |
| digital inputs not valid just after initialization? | WizardOfAz | Programming | 2 | 26-01-2004 13:21 |
Threaded Mode