|
|
|
 ...trapping Chuck Norris is worth infinity, Dave, Dean, and Woodie are 500 apiece, and trapping Andy Baker is worth double infinity - EricH [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| ...trapping Chuck Norris is worth infinity, Dave, Dean, and Woodie are 500 apiece, and trapping Andy Baker is worth double infinity - EricH [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Programming a 2nd PIC
In order to easily handle the analysis of PWM signal input I'm using a second PIC (PIC18F452) to do the calculation and plan on using the RC as the Master device where the two PICs communicate through the TTL serial line on the RC and a serial port on the demo board (PICDEM 2 Plus demonstration board from Microchip). I have a question about the programming of the 2nd PIC. Since both 40 pin PIC's are of the PIC18Fxx2 family their pin configuration and registers associated with each are the same. Does this then make it possible to transport the code that I had working on the RC to this 2nd PIC directly? Or do I have to completely rewrite my own code?
(Essentially I don't know what's in that RC box and if there is more to it then just a PIC and tracks that attach the pins to the headers for signal input on the outside) Any advice would be greatly appreciated |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VEX programming | Gene F | Programming | 14 | 08-08-2006 22:21 |
| Organizing a programming team. | scitobor 617 | Programming | 7 | 28-01-2005 19:18 |
| 'Fix It Window' and Programming.... | JMac | Programming | 19 | 25-01-2005 18:57 |
| Programming and Electronics — Getting Started | Sidney San Martín | Technical Discussion | 7 | 12-01-2005 15:25 |
| pic: Match 0105: 2nd highest score in the nation | CD47-Bot | Extra Discussion | 6 | 31-03-2003 11:14 |
Threaded Mode