|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||
|
|||
|
Re: vex programming arcade drive setting
On the tool bar just below the menu bar in EasyC, click on the button labeled "Pro". You should see additional commands in the window on the left side. Use "Motor Module Rx" and "Servo Module Rx". These commands allow you to assign any channel to any motor/servo.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming - Getting Started | Mark McLeod | Programming | 80 | 16-04-2008 23:37 |
| What should I put on my programming jump drive? | IMDWalrus | Programming | 10 | 15-01-2005 13:37 |
| Create a low speed drive in programming | Bharat Nain | Programming | 11 | 17-10-2004 20:38 |
| Globe gear box | Pat Roche | Motors | 9 | 25-05-2004 22:50 |
| what's your most important drive train advice? | Ken Leung | Technical Discussion | 42 | 07-01-2003 09:58 |