|
|
|
 You know you're addicted to FIRST when to you: 4's company, 5's a crowd, and 6 is someone off-sides. - Tetraman [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You know you're addicted to FIRST when to you: 4's company, 5's a crowd, and 6 is someone off-sides. - Tetraman [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Centroid CNC
There is this one manual I think is pretty good for learning G codes. While it does explain a lot of stuff applicable to HAAS only, it also explains a lot of G codes that are universal to any machine.
http://www.haascnc.com/training/Mill...m_PDF/xmwb.pdf You may have some problems with syntax though as the HAAS machines are very forgiving of sloppy programming and other machines may not be. Last edited by sanddrag : 28-10-2005 at 21:05. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CNC Mill Transformer | John Gutmann | Technical Discussion | 39 | 30-09-2005 02:49 |
| Help - G-Code Circular Motion for CNC Milling | sanddrag | Technical Discussion | 15 | 18-08-2004 23:00 |
| G-Codes vs. CAM / CNC Forums | indieFan | Technical Discussion | 19 | 16-06-2004 22:51 |
| To CNC? Or not to CNC? | phrontist | General Forum | 21 | 26-03-2004 13:45 |
| How hard is it to CNC this? | sanddrag | Technical Discussion | 16 | 01-03-2004 08:47 |
Hybrid Mode
