|
|
|
 Does that mean that the Ultimate Question of Life, the Universe, and Everything is, "How many total tubes will be available to score for the FRC 2011 game, LogoMotion? - EricH [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: manual control of a victor?
Googling "servo 555" turns up a few pages.
http://wolfstone.halloweenhost.com/T..._RCServos.html About half way down, that one has a circuit that uses a pot to adjust it. I haven't tried that circuit myself, but I did use a 555 to control a servo a few years back. I was looking for specific positions, so I used resistors then a small pot to fine tune it. However, I don't see any reason that you couldn't get the full range. Oh, and the victors use the same signal as servos. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Concept of PID explained | ConKbot of Doom | Technical Discussion | 11 | 27-01-2008 00:11 |
| Victor Input / Motor Control | Jack | Electrical | 5 | 01-12-2004 02:23 |
| Manual override of compressor software control | willross | Pneumatics | 15 | 18-02-2004 23:51 |
| Autonomous to Manual control? | Lint_Ninja | Programming | 5 | 16-02-2004 21:48 |
| Non-variable Victor Control | Madison | Technical Discussion | 16 | 31-01-2002 15:35 |
Hybrid Mode
