Bend Radii
I'm currently working on an endcap much like the ones included with the kitbot, but adapted to hold 20-20 extruded. My question pertains to bend radius annotation. The kitbot's bends are labeled as .62 r, but what does this mean? I've measured the radius of the actual bends to be about 1/16", so is this annotation a coefficient you put in front of the actual material thickness (1/8 by .62 is around a 1/16" bend)? I'm assuming so, but we know what assume does...
__________________
Reading makes a full man, conference a ready man, and writing an exact man. -Sir Francis Bacon
"Any intelligent fool can make things bigger, more complex, and more violent. It takes a touch of genius -- and a lot of courage -- to move in the opposite direction."
-Albert Einstein
|
The shirts. The buttons. The capes. That feeling you get when you first glimpse the arena and all the empty pits, and the only thing is promise. When the last bit of confetti has fallen, and nobody leaves the field.
We are fortunate. - Taylor [more] 
Threaded Mode