|
|
|
 I haven't seen it yet, but I have complete confidence in him, because he is Andy Baker. - Alan Anderson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I haven't seen it yet, but I have complete confidence in him, because he is Andy Baker. - Alan Anderson [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Power output on I/O port
I'm trying to mess around with the controller, and what I'm trying to reach is to provide >7 volt out of either an I/O or motor port on Channel 6.
I've noticed that the three ports are: - Common gound - V++ - Control The control signal is minimal power, and the V++ plug is constent. I was thinking of some sort of tri-state buffer, or relay so that the control signal will open up the V++... Anyone have any ideas for me? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| URGENT - No power from backup battery/PWM port voltage | Sidney San Martín | Technical Discussion | 19 | 18-11-2005 12:16 |
| Updated: Serial Port Driver Code | Kevin Watson | Programming | 4 | 05-02-2005 18:39 |
| New Serial Port Driver | Kevin Watson | Programming | 16 | 09-01-2005 01:56 |
| Dynamic Input/Output Changing | Paolo | Control System | 6 | 23-09-2004 19:09 |
| Power from competion port | rocko | General Forum | 1 | 06-02-2004 15:42 |
Threaded Mode